C-Tec NC941 Conventional Single Zone Call Controller with PSU & Reset Button

C-Tec NC941 Conventional Single Zone Call Controller with PSU & Reset Button

The NC941 Single Zone Call Controller is compatible with all 800 Series call points, ceiling pulls, infrared ceiling receivers, monitoring points, overdoor lights and remote sounders. Depending on how the Controller is configured and the devices connected to it, Standard and Emergency calls can be indicated via its buzzer and zonal LED. A button is also provided allowing the user to Reset or Mute standard calls depending on how it is configured, as detailed below.

Standard Calls: when triggered by a calling device, the Controller’s internal buzzer sounds continuously and its zone indicator illuminates steady.

If enabled for Reset operation, pressing the Controller’s button cancels all standard calls.

If enabled for Mute operation, pressing the Controller’s button silences the Controller’s internal buzzer. However, if a new call (standard or emergency) is triggered anywhere on the system, the buzzer will resound.

Emergency Calls: when triggered by a calling device, the Controller’s internal buzzer pulses and the relevant zone indicator(s) flash. This level of call takes priority over standard calls and cannot be muted or reset at the Controller. An emergency call can only be reset at the device from which it was triggered or via a reset point, wired on the same zone.

Key Features

• A single zone call controller c/w a 12V 250mA PSU and link-selectable Mute/Reset button
• Fully compatible with C-TEC’s entire range of 800 Series Call System components
• Capable of indicating standard (constant tone) and emergency (intermittent tone) calls
• Power On and Alarm ‘CALLING’ LEDs
• Open collector output goes to 12V when the controller’s onboard buzzer sounds
• Mounts on a standard UK 25mm double gang flush or surface back box